Skip to Content
  1. All products
  2. 🧠 Controllers & Systems
  3. 🖥️ Displays & Display Modules
  4. 0.91" I2C OLED Display Module (128x32)
  5. 🖥️ Displays & Display Modules
मूल्य सूची: Retail Price (B2C) मूल्य सूची
मूल्य सूची: Retail Price (B2C) मूल्य सूची
0.91" I2C OLED Display Module (128x32)

0.91" I2C OLED Display Module (128x32)

(0 review)
SpecificationDetails
Screen Size0.91 Inch Diagonal
Resolution128 x 32 Pixels
Driver ICSSD1306
InterfaceI2C (IIC) Serial
Pixel ColorBlue
Operating Voltage3.3V to 5V DC
Viewing Angle> 160°
Price
₹ 165.25 ₹ 165.25
(Tax included)

Product Description

The 0.91" 128x32 OLED is built for simplicity and efficiency. It uses the widely supported SSD1306 controller, which is compatible with almost all microcontroller platforms, including Arduino, ESP32, and Raspberry Pi. The long, narrow aspect ratio is specifically optimized for displaying text strings, horizontal progress bars, and small icons. Its 4-pin interface (VCC, GND, SCL, SDA) minimizes wiring complexity, making it ideal for prototypes where GPIO pins are at a premium.

Key Features

  • Self-Illuminating: Each pixel is an independent light source, providing a high contrast ratio that is easily readable in bright or dark environments.

  • Low Power Usage: Consumes very little power, especially when displaying minimal text, making it perfect for battery-operated devices.

  • Ultra-Slim Profile: Without a backlight assembly, the module is only a few millimeters thick, allowing it to fit into slim handheld enclosures.

  • Wide Viewing Angle: Maintains color and clarity even when viewed from extreme side angles up to 160 degrees.

  • Hardware Addressable: Most modules allow you to select between two I2C addresses (usually 0x3C or 0x3D) by moving an onboard resistor.

Technical Details

  • Dimensions: Approximately 38mm x 12mm.

  • Communication: I2C serial bus (requires only 2 data lines).

  • Display Color: Bright blue pixels on a deep black background.

Prototyping and Engineering Tips from Robogears

  • The "Row Offset" Rule: Because this is a 128x32 display, standard 128x64 code might display text incorrectly. In your library initialization (like Adafruit_SSD1306), ensure you specify the 32-pixel height to correctly map the display memory.

  • I2C Address Check: Most 0.91" modules use the I2C address 0x3C. If the screen remains blank during your first test, run an "I2C Scanner" sketch to confirm the address of your specific hardware.

  • Powering from 3.3V vs 5V: While the module is 5V tolerant, it is native 3.3V hardware. If you are using an ESP32 or Raspberry Pi, connecting to the 3.3V rail is more efficient and reduces stress on the onboard regulator.

  • Fragile Glass Edge: The glass on these displays is extremely thin at the edges. When mounting, ensure the PCB is supported and that the glass does not receive direct mechanical pressure from your enclosure's bezel.

Package Includes

  • 1 x 0.91" I2C 128x32 Blue OLED Display Module

Disclaimer

Reverse polarity (swapping VCC and GND) will result in immediate failure of the driver IC. Always verify the pin labels on the PCB before connecting power.