Skip to Content
  1. All products
  2. 🧠 Controllers & Systems
  3. 📡 Sensors & Modules
  4. DS18B20 Digital 1-Wire Temperature Sensor Module for Arduino
  5. 📡 Sensors & Modules
मूल्य सूची: Retail Price (B2C) मूल्य सूची
मूल्य सूची: Retail Price (B2C) मूल्य सूची
DS18B20 Digital 1-Wire Temperature Sensor Module for Arduino

DS18B20 Digital 1-Wire Temperature Sensor Module for Arduino

(0 review)
SpecificationDetails
Operating Voltage3.0V to 5.5V DC
Measuring Range-55°C to +125°C
Accuracy±0.5°C (from -10°C to +85°C)
ResolutionUser-selectable 9 to 12 bits
Interface1-Wire (Digital)
Conversion Time< 750ms (at 12-bit resolution)
Current Consumption1mA (Active) / 3µA (Standby)
Price
₹ 76.27 ₹ 76.27
(Tax included)

Product Description

The DS18B20 Module is designed for easy integration, featuring a pre-mounted sensor on a PCB with a built-in power indicator LED. It can be powered directly from the data line ("Parasite Power" mode), eliminating the need for an external power supply in some configurations. Because the output is digital, it is immune to electrical noise, making it the industry standard for environmental monitoring, industrial systems, and consumer thermal control products.

Key Features

  • Single-Wire Communication: Only one digital port is needed for communication, saving valuable I/O pins on your Arduino or ESP32.

  • Unique ID per Sensor: Every sensor has a hard-coded 64-bit address, allowing a single microcontroller to read dozens of sensors on one bus.

  • Digital Accuracy: No external ADC is required; the sensor sends the temperature value directly in degrees Celsius.

  • Alarm Functionality: Includes non-volatile, user-programmable upper and lower trigger points for temperature alarms.

  • Wide Compatibility: Works seamlessly with 3.3V and 5V logic systems

Technical Details

  • Logic Level: 3.3V/5V compatible.

  • Pinout: VCC, GND, and DATA.

  • Mounting: Includes a 3mm hole for secure chassis mounting.

Prototyping and Engineering Tips from Robogears

  • The Pull-up Resistor: The 1-Wire bus requires a 4.7kΩ pull-up resistor between the DATA pin and VCC. While many modules have this resistor pre-soldered, always check with a multimeter. If your readings are consistently "85°C" or "0°C," a missing or incorrect pull-up resistor is the likely culprit.

  • Parasite Power Mode: For very long wire runs or to save wire, you can connect the VCC and GND pins of the sensor together to Ground. The sensor will then "steal" power from the data line during high-logic states. Note that this mode requires slightly more careful timing in your software.

  • Resolution vs. Speed: If you need very fast updates, set the resolution to 9-bit (0.5°C increments), which takes only 93.75ms to convert. For high precision, use 12-bit (0.0625°C increments), but be prepared for the 750ms delay per reading.

  • Waterproofing: If you intend to measure liquid temperatures (like a fish tank), do not use this PCB module. Instead, look for the waterproof DS18B20 probe version, which houses the sensor in a stainless steel tube with sealed wires.

Package Includes

  • 1 x DS18B20 Digital Temperature Sensor Module

Disclaimer

Avoid placing the sensor in direct contact with high-voltage components or corrosive chemicals. Ensure the operating voltage does not exceed 5.5V to prevent internal IC failure.