Skip to Content
  1. All products
  2. Sensors & Modules
  3. YF-S201 Water Flow Sensor – G1/2" Interface, 1-30L/min Flow Rate, Hall Effect Liquid Flowmeter for Arduino & Liquid Management
  4. Sensors & Modules
मूल्य सूची: Retail Price (B2C) मूल्य सूची
मूल्य सूची: Retail Price (B2C) मूल्य सूची
YF-S201 Water Flow Sensor – G1/2" Interface, 1-30L/min Flow Rate, Hall Effect Liquid Flowmeter for Arduino & Liquid Management

YF-S201 Water Flow Sensor – G1/2" Interface, 1-30L/min Flow Rate, Hall Effect Liquid Flowmeter for Arduino & Liquid Management

(0 review)
FeatureDetails
ModelYF-S201
Sensor TypeHall Effect (Magnetic)
Operating Voltage5V to 18V DC
Flow Rate Range1 to 30 Liters/Minute
Pipe ConnectionG1/2" (Standard 1/2 inch)
Maximum Pressure≤ 1.75 MPa
Price
₹ 211.86 ₹ 211.86
(Tax included)

Product Description & Technical Details

Product Description

The YF-S201 Water Flow Sensor is a reliable and easy-to-use device for measuring the volume and speed of liquid passing through a pipe. It consists of a plastic valve body, a water rotor, and a Hall-effect sensor. As water flows through the sensor, the rotor spins at a speed proportional to the flow rate. The Hall-effect sensor outputs a corresponding pulse signal (square wave) for every revolution. This pulse can be easily read by any microcontroller's interrupt pin. At Robogears, we recommend this sensor for smart irrigation systems, automatic water dispensers, and solar water heater monitoring.

Key Highlights

  • Universal Standard Fitting: Features G1/2" threaded connections, making it compatible with most standard household plumbing, PVC pipes, and garden hoses.

  • Precise Measurement: The magnetic Hall-effect design ensures that the electronics are completely isolated from the water, preventing corrosion and ensuring a long service life.

  • Simple 3-Wire Interface: Follows standard industrial wiring: Red (VCC), Black (GND), and Yellow (Pulse Output).

  • Robust Construction: The valve body is made of high-quality plastic with an internal stainless steel axis for the rotor, capable of withstanding pressures up to 1.75 MPa.

  • Low Power Requirement: While it can operate up to 18V, it works perfectly on 5V logic, making it directly compatible with Arduino, ESP32, and Raspberry Pi.

Technical Specifications

  • Output Duty Cycle: 50% ± 10%

  • Flow Pulse Characteristics: $f = (7.5 \times Q)$ where $f$ is frequency in Hz and $Q$ is flow rate in L/min.

  • Operating Humidity: 35% to 90% RH (No frost)

  • Storage Temperature: -25°C to +80°C

  • Dimensions: 62.5mm x 36mm x 35mm


Installation Tip from Robogears

When installing, ensure the arrow on the sensor body matches the direction of the water flow. To calculate the total volume of water used, you need to count the pulses in your code using an Interrupt. Use the formula: Total Liters = (Pulse Count / 450), as the sensor typically produces approximately 450 pulses per liter. Note: This sensor is designed for clean water only; if you are using it with greywater or liquids containing debris, we strongly advise installing a filter upstream to prevent the internal rotor from jamming.

Note: This product is the YF-S201 Flow Sensor ONLY. Plumbing adapters and Teflon tape are not included. Product images are for illustration purposes only.