Skip to Content
  1. All products
  2. Switches
  3. 6x6x5mm Tactile Push Button Switch – 4-Pin Momentary PCB Micro Switch for Arduino, ESP32, and Prototype Electronics (Standard Height) (Pack of 3)
  4. Switches
Pricelist: Retail Price (B2C) Pricelist
Pricelist: Retail Price (B2C) Pricelist
6x6x5mm Tactile Push Button Switch – 4-Pin Momentary PCB Micro Switch for Arduino, ESP32, and Prototype Electronics (Standard Height) (Pack of 3)

6x6x5mm Tactile Push Button Switch – 4-Pin Momentary PCB Micro Switch for Arduino, ESP32, and Prototype Electronics (Standard Height) (Pack of 3)

(0 review)
FeatureDetails
Dimensions6mm x 6mm (Base) x 5mm (Total Height)
Switch TypeMomentary (Normally Open)
Rating50mA 12V DC
Mounting TypeThrough-hole (4-Pin DIP)
Tactile Force160gf (Standard)
Travel0.25mm $\pm$ 0.1mm
Price
₹ 8.47 ₹ 8.47
(Tax included)

Product Description The 6x6x5mm Tactile Switch is the industry-standard "low-profile" momentary button. With a total height of just 5mm, it is designed for surface-level interaction on PCBs where a flush or near-flush finish is required. This switch is the "bread and butter" of the electronics prototyping world and a vital part of the Robogears Pvt Ltd toolkit. Its 4-pin design provides excellent mechanical stability, ensuring the switch stays firmly seated on the board during repetitive use in consumer electronics, remote controls, and microcontroller-based projects.

Key Highlights

  • Universal Standard Height: The 5mm height is the most common size, making it highly compatible with standard plastic button caps and existing enclosure designs.

  • Breadboard & PCB Ready: Features pins spaced specifically for 2.54mm (0.1") pitch, allowing it to snap directly into solderless breadboards for rapid R&D.

  • Superior Mechanical Stability: Although it functions as a 2-terminal switch, the 4-pin footprint prevents the component from tilting or breaking off the solder pads under heavy thumb pressure.

  • Clean Tactile "Click": High-quality internal stainless steel domes provide a sharp, audible feedback sensation, reducing the chance of accidental or incomplete presses.

  • High Chemical Resistance: Constructed from high-temperature PBT/Nylon, making it resistant to flux and cleaning agents used during the soldering process.

Technical Specifications

  • Contact Resistance: $\leq 100$ m$\Omega$

  • Insulation Resistance: $\geq 100$ M$\Omega$ at 100V DC

  • Dielectric Strength: 250V AC for 1 minute

  • Operating Temperature: -25°C to +70°C

  • Mechanical Life: $> 100,000$ Cycles

  • Soldering Temp: 260°C for 3 seconds

[Diagram showing the 4-pin internal connection: The top two pins are internally shorted to each other, and the bottom two are shorted to each other]

Prototyping & Installation Tip (Standard Wiring) When wiring this for an Arduino or ESP32 at Robogears, remember that the pins are connected in pairs. If you look at the bottom, the two pins on the same "flat" side are already connected. To make the switch work, you must connect your wires to the pins on opposite sides of the plastic body. Using a 100nF capacitor across the switch pins can provide "hardware debouncing," ensuring your software doesn't register a single click as a double-click.

[Image showing the 6x6x5mm switch used as a boot/reset button on a development board]

Note: This product includes 1 x 6x6x5mm Tactile Switch. Product images are for illustration purposes only.